When performing hardware processing, it is inevitable to use a variety of mechanical equipment, so there will be a lot of precautions in operating these hardware processing equipment. Please note that some of these devices may also be dangerous, so you should not only pay attention when operating, but also some items may be prohibited, so be sure to understand these precautions and taboos before operating If you are familiar with all the items, you need to carry out pre-employment training, and you can only operate after meeting the requirements. The following is a brief introduction to some common precautions in processing.
Hardware processing equipment mainly pays attention to these aspects, so first of all, the first question is about the education and training of employees' clothing and safety. For example, you can’t wear slippers when operating, and don’t grow your hair long. In addition, those who should wear hard hats should wear hard hats, and those who should wear protective clothing should wear protective clothing . These are the problems that should be paid attention to when operating. Next, the second thing to pay attention to is the inspection before operation. There are pieces of equipment that need to be lubricated, pieces of equipment that have controllers on them, pieces of equipment that have clutches on them, and so on. Therefore, checks must be carried out before operating these devices. The place where the lubricating oil should be added is called lubricating oil, and the place that should be reset must be reset. Those who should carry out idling start will carry out idling start and so on. The third problem that needs attention is to check the power supply. Because some equipment needs to use the power supply, it is necessary to check whether the power supply is normal, and then the neutral wire, live wire and ground wire, whether these lines are connected normally.
A few issues that need to be paid attention to in hardware processing equipment are temporarily shared with you here. Since there are many such devices, there may be some differences in the problems that need to be paid attention to when operating different types of devices. For example, some are winding machines, while others are stamping machines. Various types of machines emerge in endlessly, so naturally there are certain differences in the requirements for different machines to operate. It is recommended that before operating these machines, all employees should be familiar with these devices, and then know the dangers of these devices, and know which operations are correct and which operations are wrong.
